Suzhou Step into Room Salt Spray Box/Large Salt Spray Room.

NegotiableUpdate on 01/22

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The salt spray corrosion environment simulation laboratory can simulate typical environmental conditions in nature at any time without being limited by time and season. Putting the product into an environmental simulation laboratory for environmental simulation testing, replacing the usage environment with a simulated environment, can save a lot of manpower and material resources, and save development costs. At the same time, environmental simulation testing is based on the product's usage environment conditions, controlling the product's usage conditions. The testing has an "acceleration" property, which can shorten the product's testing cycle.

Product Details

1、 Main parameter indicators of the equipment

1. Equipment model: AB-200

2. Studio size: 3000 mm x 2000 mm x 2000 mm (depth x width x height) (excluding spire)

3. Door: Open the door, 2200mm × 2000mm, Double leaf (interior: made of polypropylene material, with double-layer silicone rubber seal and door lock).

4. Temperature range: 35 ℃ -50 ℃

5. Temperature fluctuation: ± 0.5 ℃ (when unloaded)

6. Temperature deviation: ± 2 ℃ (when unloaded)

7. Temperature gradient: ≤ 2 ℃

8. Salt spray settling amount:1-5 ml/h/80cm2adjustable

9. Salt water concentration: adjustable from 0.5% to 5%

10. Test time: 0-999 H, M, S; How to translate

11. Observation window: 350 × 500mm (length × height)

12. spray mode: air flow spray, continuous/intermittent.

13. Bottom load-bearing capacity: ≥ 0.5T

15. Average * working hours:>2000h

16. Average lifespan:>10 years

17. Noise: ≤ 75dB

18. Rated voltage of the laboratory: AC (380 ± 38) V 50Hz ± 0.5Hz

The material combination of the outer wall and the inner liner is as follows:

Outer made of polypropylene material with a thickness of 12mm

1.2 The salt spray test stipulates that the water droplets formed by spray shall not fall on the test piece, and the included angle on the top of the test room shall have a certain angle, generally as follows:110o. Thus, the formed droplets flow along the apex to both sides of the laboratory.

1.3 Gate: It is one of the key components of the room. It can meet the requirements of convenient entry and exit of sample vehicles, good insulation, no cold running or condensation around, and lightweight switches. The fourth is good sealing and no salt spray leakage.

1.4 Floor: The channel steel bottom plate is reinforced with hard polyurethane foam material, and SUS316L (1.5mm thick) stainless steel plate is laid on the surface to ensure the overall compressive strength and wear resistance of the bottom surface. The ground is inclined from the outside to the inside towards the collection tank at a certain angle to facilitate the quick discharge of atomized water.