-
E-mail
jeffreywang@taihao-hz.cn
-
Phone
13858065668
-
Address
Room 231-232, Building 6, Xixi Century Center, No. 136 Shuanglong Street, Xihu District, Hangzhou City
Product Categories
Hangzhou Taihao Technology Co., Ltd
Quartz crystal monitoring instrument
NegotiableUpdate on 04/29
- Model
- Nature of the Manufacturer
- Producers
- Product Category
- Place of Origin
Overview
The quartz crystal monitor has a smaller size, lower cost, and the same performance as traditional QCM. In measuring the deposition rate and film thickness of thin films, INFICON's new Q-podTM sensor is a compact, low-cost, and accurate measurement solution.
Product Details
Quartz crystal monitoring instrument
In measuring the deposition rate and film thickness of thin films, INFICON's new Q-podTMSensors are a compact, low-cost, and accurate measurement solution. Its installation and operation are extremely simple. Simply connect one end of the Q-pod measuring instrument to the QCM sensor probe through a BNC cable, and the other end to a personal computer using a standard USB interface, without the need for an additional oscillator or power supply. Then, install the Q-pod software that we provide for free and start working. The Q-pod software can display deposition rate, film thickness, frequency, chip lifespan, as well as relative curves of deposition rate and coating time, and can simultaneously monitor 8 Q-pod signals. The readings of Q-pod can be recorded in a data table on the computer's hard drive, separated by commas for easy retrieval at any time.
Standard Q-pod system configuration: -Pod monitoring box\\\\Sensor probe\\\\1-inch bolt type flange\\\\Crystal oscillator, 10 pieces
Quartz crystal monitoring instrument
Product Features:
◆ Smaller volume, lower cost, with the same performance as traditional QCM
◆ It can be directly connected to a computer through a USB interface and supports the simultaneous connection of 8 Q-pod monitoring devices
Based on WindowsWindow software, including operation and data recording
Weight less than 2 ounces (1 ounce=28.35g),Can easily fit into the top pocket
Q-POD - Software:
The dialog box on the right displays the main settings and operation interface of the software, including the connection to Q-pod. This software can simultaneously support 8 Q-pods connected to a personal computer, with each Q-pod requiring a USB interface.
Q-POD - Simple QCM System:
The system architecture diagram on the right shows a typical thin film deposition system.
A complete Q-pod system includes a Q-pod monitoring box, sensor probes, connecting flanges, and a computer.
performance parameters
probe |
Compatible with any type of QCM probe |
frequency range |
1 to 10 MHz |
resolution |
0.05 Hz at 6 MHz |
Frequency accuracy |
0.002 % |
Frequency stability |
± 2 ppm total, over 0? to 50? C |
input |
BNC |
Interface and power supply |
USB, v2.0 or later |
size |
1' x 2' x 2.5' （25 x 50 x 64 mm） |
weight |
2 oz （32 gm） |
software |
Provide display and setting of all working parameters |
Computer requirements |
Anything that can runWindows? XP、2000,A personal computer with at least one USB excuse |
Order information
Q-pod |
QCM sensor probe, including: |
-Windows based setting operation software | |
-QCM probe simulator | |
-6 '(150mm) BNC cable (connecting Q-pod and probe flange) | |
-10 '(3m) USB cable (connecting Q-pod and PC) | |
The complete set includes: QCM crystal oscillator, probe, flange, and other accessories for use with Q-pod | |
