Hydrochloric acid mist waste gas treatment tower Guanting

Hydrochloric acid mist waste gas treatment tower GuantingThe hydrochloric acid mist waste gas treatment tower uses 5% to 10% sodium hydroxide solution as the absorption solution. The absorption solution of the hydrochloric acid mist waste gas treatment tower is pumped into the top of the tower through a water pump, and then falls back to the bottom solution tank of the tower through a water distributor and packing layer. Repeat this process until it approaches saturation absorption before replacing with a new alkaline solution. The waste gas (neutral or acidic organic gas) emitted during production is introduced into the inlet section of the hydrochloric acid mist waste gas treatment tower through positive pressure at the outlet of the centrifugal fan. The gas flows upward through three layers of packing layers through the uniform air plate and reacts with the neutralizing liquid sprayed from each layer of nozzle. The gas-liquid undergoes sufficient neutralization and absorption. After passing through two liquid blocking devices and defogging, the gas is discharged into the atmosphere through the chimney at the top of the tower.

Configuration instructions for hydrochloric acid mist waste gas treatment tower:
1. The exhaust gas is collected through pipelines and sent to the hydrochloric acid mist exhaust gas treatment tower for treatment.
2. The air duct and hydrochloric acid acid mist waste gas treatment tower shall be connected with corrosion resistant and anti-aging stainless steel screws.
3. The water pump adopts a corrosion-resistant and wear-resistant mortar pump.
4. The motor of the water pump adopts explosion-proof motor.
Characteristics of hydrochloric acid mist waste gas treatment tower:
1) The hydrochloric acid mist waste gas treatment tower includes a packing layer, a spray device, nozzles arranged on the spray device, and a defogger.
2) The liquid/gas ratio is low, thereby saving the power consumption of the circulating spray liquid pump.
3) There is no scaling or blockage on the internal surface and tray of the hydrochloric acid mist waste gas treatment tower.
4) The spray liquid in the slurry pool of the hydrochloric acid mist waste gas treatment tower is sent to the nozzle through the spray pipe group by the slurry circulation pump, forming very small droplets that are sprayed into the tower.
5) There is a vent valve installed at the top of the hydrochloric acid mist waste gas treatment tower, which is closed during normal operation. When the device is bypassed or when the device is shut down, the vent valve opens. Exhaust system, mainly consisting of chimneys.
Hydrochloric acid mist waste gas treatment tower GuantingFixed method:
1. The bottom of the hydrochloric acid mist waste gas treatment tower water tank is fixed around with expansion screws and cement foundation embedded parts.
2. The hydrochloric acid mist waste gas treatment tower can be installed on the top of the workshop and fixed with three cables.