Electrical conduit bending test, mechanical and electrical guide tester, plastic pipe detection

Electrical conduit bending test, mechanical and electrical guidance tester, plastic pipe detection. This testing machine is suitable for bending tests of insulating electrical conduit and other materials. The total bending angle is 180 °. After the test, observe whether there are cracks in the sample. Meets the requirements of GB/T14823.2 "Special Requirements for Conduits for Electrical Installation - Rigid Insulated Material Flat Conduits", JG/T3050 "Insulated Electrical conduit and fittings for buildings", and ZBG33008 "Polyvinyl chloride plastic corrugated conduit".

This test machine can test three types of conduits specified in the standard on one device without the need to change the forming mold or bending roller.

2、 Electrical conduit bending test, mechanical and electrical guide tester, plastic pipe detection technical parameters:

1. Sample catheter diameter: 16 20 25mm

2. Bottom radius of forming die groove: 48 60 75mm

3. Curved roller center trajectory radius: 84 105 131.25mm

4. Forming mold and bending roller groove radius; 8.1 10.1 12.6mm

5. Curved roller groove bottom diameter: 24 30 37.5mm

6. Total bending angle of the sample: 180 °