Spray dryer for solution condensation recovery

The solution deposition condensation recovery spray dryer is suitable for universities, research institutes and laboratories of food, medicine and chemical enterprises to produce micro particle powder, and is widely applicable to all solutions such as emulsion and suspension, and is suitable for drying heat sensitive substances such as biological products, biological pesticides, enzymes, etc. Because the sprayed material only experiences high temperature and instant heating when sprayed into a mist, these active materials maintain their active ingredients unchanged after drying.

　　Spray dryer for solution condensation recoverySuitable for the production of trace particle powders in universities, research institutes, and laboratories of food, pharmaceutical, and chemical enterprises. It has wide applicability to all solutions such as emulsions and suspensions, and is suitable for drying thermosensitive substances such as biological products, biopesticides, enzyme preparations, etc. Because the sprayed material only experiences high temperature and instant heating when sprayed into a mist, these active materials maintain their active ingredients unchanged after drying.

Specifically used in the following fields: beverages, spices and pigments, milk and egg products, plant and vegetable extracts, pharmaceuticals, synthetic thermosensitive substances, plastics, polymers and resins, aromatic agents, blood products, ceramics and superconductors, biochemical products, dyes, soaps and detergents, food adhesives, oxides, bone powder and tooth powder, etc.

　　Spray dryer for solution condensation recoveryCharacteristics:

1. The drying speed is fast. After being atomized by an atomizer, the surface area of the liquid is greatly increased, and 95-98% of the water can be evaporated instantly in a high-temperature airflow, completing the drying process in just a few seconds.

2. Parallel flow spray drying can make the droplets flow in the same direction as the hot air. Although the temperature of the hot air is high, because the hot air enters the drying room and immediately contacts with the spray droplets, the indoor temperature drops sharply, and the materials will not be excessively heated. It is also suitable for

Drying of thermosensitive materials.

3. Due to the instantaneous drying process, the particles of the finished product can basically remain spherical, and the product has good dispersibility, flowability, and solubility.

4. The production process is simplified and the operation control is convenient. Spray drying is usually used for drying solutions with a moisture content of 50-80%. Even if the moisture content of special materials is up to 90%, they can be dried into powder products at one time. After most products are dried, there is no need for further crushing and screening, which reduces the production process, simplifies the production process, and improves the purity of the products. According to production

The required particle size, bulk density, and moisture content of the product can be adjusted and controlled by changing the operating conditions within a certain range.

5. In order to prevent material contamination and extend equipment service life, all parts in contact with the material are made of SUS304 stainless steel material. For the convenience of operation, the operating system adopts integrated control, that is, installing indicator devices and opening and closing devices for each component in the control cabinet.