SEW-TP553 Fully Automatic Trace Moisture Analyzer

SEW-TP553 Fully Automatic Trace Moisture AnalyzerBy using microcontroller technology, the instrument has achieved dew point PPmV、 Automatic conversion between units such as humidity, without the need for manual table lookup conversion. The circuit part of the instrument is reliable. In order to meet the needs of field operations, the instrument uses both AC and DC, and the built-in battery can work continuously for more than 20 hours, which expands the range of use and greatly facilitates users.

Product Features:

1. The original battery has been replaced with a lithium-ion battery with high energy density, small size, and light weight. The charging module adopts a fully automatic power management mode of automatic charging and automatic shutdown. Even if the user does not turn on the power switch, it can be automatically charged as long as the 220V AC power is plugged in. When the battery is fully charged, the system will automatically determine and cut it off. This effectively prevents overcharging of the battery by electricity. During use, the instrument will detect a decrease in battery level and automatically shut down when the battery level drops below 5%. Effectively preventing over discharge of the battery to avoid damage to the battery.

2. The intelligent micro water meter, after the record is saved, the user can't remember which equipment is measured in that record. In view of this situation, the equipment number column is added to each record, that is, the user needs to enter the equipment number when saving the record, and can check the corresponding record according to the equipment number when calling up in the future.

Note: The name of the test device can be entered in a total of six digits, each consisting of 10 Arabic numerals from 0-9. Users can use the up and down keys to modify each digit, and the left and right movement keys to determine each digit. Convenient to use units

Notes:

◆SEW-TP553 Fully Automatic Trace Moisture AnalyzerIt should be placed in a safe location to prevent damage from falling and avoid excessive heat and vibration.

Users are not allowed to open the instrument without authorization.

Do not test for corrosive gases.

The probe should be cleaned and calibrated after a certain period of use, with a calibration interval of one year. When calibration is required, please contact our company.

When adjusting the gas flow rate, the control needle valve should be slowly opened to indicate a flow rate of 0.5-0.6 liters per minute.

After one day of use (using batteries), the instrument should be charged in a timely manner. When charging, simply connect the power cord to a 220V socket without turning on the power switch. The instrument will automatically charge, and the charging time is generally more than 5 hours.