Omron encoder

The Omron encoder can achieve Z-phase logic inversion through the front switch. It can also be connected to any type of voltage output or open collector output.

The incremental encoder outputs pulses when it rotates, and its position is known through a counting device. When the encoder is stationary or powered off, it relies on the internal memory of the counting device to remember its position.

In this way, when there is a power outage, the encoder cannot move in any way. When there is a power outage, the encoder outputs pulses during the process,

There should also be no interference causing the loss of pulses, otherwise the zero point remembered by the counting device will shift,

And the amount of this offset is unknown, only after the occurrence of incorrect production results can it be known.

The output of a linear drive refers to the data transmission circuit according to RS-422A. Long distance transmission can be achieved through twisted pair cables. (Equivalent to hidden AM26LS31)

The electrical response speed is determined by the resolution and response frequency.

Radial load 30N

Axial 20N

Allowable speed 6000r/min

Protection circuit load short circuit protection, power reverse connection protection -

Environmental temperature range: -10 to+70 ° C during operation, -25 to+85 ° C during storage (without icing)

Environmental humidity range: 35-85% RH during operation and storage (no condensation)

When the power is turned on, a surge current of about 9A flows. (Time: approximately 0.3ms)