ME001 Mini Two Point Electrode

Test on the materials of the RT-1000 megohmmeter. After selection, press the 10 or 100 volt test button until the reading is displayed on the LCD screen. The humidity, temperature, and resistivity (ohms/square. displayed) values will appear on the instrument display, and the instrument will automatically shut down for about 45 seconds.

An alternative method is to use an optional concentric ring probe.

Resistance/RTG/RTT:

Resistance/RTT: Two 5 pounds each

The probes are 3 feet away from each other on the measured surface. Add an additional 3.5mm to the meter, then insert a 5-pound test probe into the banana plug end. Press the power button of the instrument until the resistance reading displayed on the LCD screen is in ohms.

RTG: (Ground Resistance) Conduct a test on the surface detected at current position 1, with a distance of 3 feet from a common point to ground. one

Connect the line to the ground position of the instrument and other common points. This may be at the grounding point of the unit. Press the power button in meters until the reading is displayed in ohms.

​

• Compliant with ANSI/ESD STM11.13 and IEC61340-4-10 specifications

• Test line socket: standard 4mm socket

• Conductive rubber pad diameter: 3mm

• Center distance between 2 rubber pads: 6mm

• Probe can be plugged and replaced

• Wearing a protective hat

• Instrument adaptation:

  TOM600，19290，ACL800，RT-1000，1978419640701 Tester