Fully automatic oil separation and lifting equipment for commercial complexes

Fully automatic oil separation and lifting equipment for commercial complexesThe tank is a closed device that prevents contact between gas and water, ensuring that the water quality is not contaminated by external factors. A pressure gauge is installed near the pump outlet, and the operation follows the principle of first on, first off to balance the workload of each pump.

1. Open the exhaust valve of the water pump to remove gas;
2. Automatic alternating operation function: enables the sewage pump to operate uniformly, extending the service life of the sewage pump and related accessories.
3. Relative humidity of the air: 20% -90% (no condensation);
After the installation of the equipment is completed without any problems, soil can be filled around the equipment and compacted in the gaps, and the ground should be leveled. When filling the soil, attention should be paid to: the equipment manhole cover must be about 50mm higher than the floor; Do not allow soil to block the air inlet on the manhole cover plate.
5. After the equipment is in place, it is required to fix the lower end with anchor bolts;
6. Manually start and stop each water pump one by one, and check that there are no abnormal phenomena in the operation of the water pumps;
7. Fault interlocking function: When one sewage pump cannot operate, start another sewage pump as a backup pump to achieve safe use.
8. Built in sewage treatment equipment, paying attention to every detail of the product. The equipment is equipped with a reamer submersible sewage pump, which can crush various sanitary products, plastic bags, cloths, and other fiber garbage in the sewage, as well as kitchen fruit and vegetable garbage into fine foam and discharge it together with the sewage.
9. According to changes in water usage, it becomes the start and stop of multiple pump units.

1. Firstly, check the direction of the water pump when it is in automatic mode. If it is in reverse, adjust the position of any two phase lines of the power supply inlet; Then switch to manual start each pump, and if it is reversed, adjust the water pump motor line accordingly;
2. There is LED frequency indication, frequency conversion abnormal indication, and motor fault condition display.
3. The remote pressure gauge should be installed on the user's pipeline, on the main pipe after the outlet check valve;
4. Places without conductive dust that can corrode metals and damage insulation gases in Egypt;
5. The compact design of building utilization products not only makes the appearance beautiful, but also occupies a small area, is easy to install, saves basement space, and greatly reduces operating and civil engineering costs.
6. Fully automate the entire process of soft start, frequency conversion to power frequency operation, and stop for multiple water pump units.
7. Please note that the installation diagram and pipeline connection diagram of this equipment should be connected and arranged according to the standard layout and plan.
8. Daily water supply for enterprises, institutions, hotels, office buildings, department stores, large saunas, hospitals, schools, sports halls, golf courses, airports and other places.
9. The equipment ventilation pipe should be connected to the outdoor or to the building's drainage and ventilation system;
10. Keep the mechanical seal in good lubrication condition under normal conditions to improve the service life of the mechanical seal.
11. Fully enclosed structure design, no odor or leakage, eliminating pollution and improving the environment.
12. For other matters not covered, please refer to the corresponding specifications.
13. Vibration:<5.9m/s2 (0.6G), inclination: ≤ 5 degrees in places;
When the water in the sewage lifting tank reaches the preset height, the water pump starts to lift the sewage to the municipal pipeline network. When the sewage drops to the set height at the bottom, the water pump stops running.
Fully automatic oil separation and lifting equipment for commercial complexes