-
E-mail
zhangbd@keyontechs.com
-
Phone
18317143469
-
Address
No. 7 Xinghao Road, Fengjing Industrial Park, Jinshan District, Shanghai
Product Categories
Shanghai Keyang Technology Co., Ltd
Electromagnetic flowmeter F series
NegotiableUpdate on 05/17
- Model
- Nature of the Manufacturer
- Producers
- Product Category
- Place of Origin
Overview
The F series electromagnetic flowmeter consists of a sensor and a converter. It operates based on Faraday's law of electromagnetic induction and is used to measure the volumetric flow rate of conductive liquids with a conductivity greater than 5 μ S/cm. In addition to measuring the volume flow rate of general conductive liquids, it can also be used to measure the volume flow rate of strong corrosive liquids such as strong acids and alkalis, as well as homogeneous liquid-solid two-phase suspensions such as mud and slurry. It is widely used in flow calculation in industrial sectors such as petroleum, chemical, metallurgical, textile, papermaking, environmental protection, food, as well as municipal management, water conservancy construction, river dredging and other fields
Product Details
Product performance
Stable and reliable traffic
high precision
No pressure loss
Strong vibration resistance
Easy installation and debugging
key parameters
| Nominal meridian: DN15~DN1200 Electrode materials: 316L, Hb, Hc, Ti, Ta, Pt Lining materials: chloroprene rubber, polyurethane PTFE、PFA、F46 Dielectric conductivity: ≥ 5 μ s/cm, softened water is 20 μ s/cm Accuracy level: ± 0.5% RS~± 1.0% RS Flow velocity range: 0.3m/s~12m/s Environmental temperature: -20 ℃~+60 ℃ Medium temperature: A: ≤ 80 ℃; B≤120℃； C ≤ 180 ℃ (split PTFE lining) Nominal pressure: 0.6MPa~4.0MPa (customized according to caliber or special requirements) Protection level: IP65, IP67, IP68 (split) Output signal: 4~20mA, frequency/pulse, alarm output Communication output: RS485, RS232, MODBUS485, HART, PROFIBUS DP Power supply voltage: 220AC, 24VDC Installation form: integrated or split Flange standards: National Standard, American Standard, Japanese Standard, German Standard Shell and flange materials: standard stainless steel, carbon steel, etc |
Install
|
The installation direction of the sensor can be horizontal, vertical, or inclined without any restrictions. In order to ensure that the measuring tube is filled with the measured medium, when the sensor is installed vertically, the flow direction is from bottom to top; If only horizontal installation is allowed on site, try to ensure that the two electrodes are on the same horizontal plane as much as possible, and the axis of the electrodes must be approximately horizontal with an inclination of no more than 45 degrees. | 
|
