600g/0.01g meltblown fabric sampling knife

600g/0.01g meltblown fabric sampling knife

Introduction to Sampler:

Cutting area：100cm2

cutting thickness：0.1mm-5mm

Machine dimensions：400*240*550mm

blade size：diameter112.84mm（100square centimeter）

outer packaging dimensions：400*260*370mm

This instrument is suitable for cutting various woolen fabrics、cotton spinning、chemical fiber、Circular samples of knitted and other fabrics.

Sampling area：100cm2,Weigh the cut sample in grams using an electronic balance，again*100It is the weight per square meter of textile，very convenient！！

Instructions for using the disc sampler：

Lay the fabric to be cut flat on the rubber pad，Place the disc sampler on the fabric，Pull out the locking device on the sampler，Rotate about90degree，Hold the outer cover with one hand，Grasp the corrugated handwheel with one hand，And apply a certain amount of pressure，Then rotate the corrugated handwheel clockwise（Corner greater than90degree），You can cut the round sample.

Lock the device immediately after using the sampler，Rotate to the original position，Keep the blade from being exposed，To avoid injuring hands and other objects.Structure and Adjustment:

The cutting blade is a double-sided blade with a total of four pieces，To evenly distribute the four equal parts of the circle externally，The blade can be replaced，Specific operation is：Loosen the cross screw（There are four screws on each piece），Remove the blade pressure plate and sampling blade，Replace with a new blade，Press the blade pressure plate，Pay attention to making the blade edge clockwise and tangential，And make the four blade edges in the same plane，Then tighten the cross screw.

There are straight lines and scratches on the bottom of the instrument，Used to fix the sample，Easy to cut，Prevent sample slippage.

600g/0.01g meltblown fabric sampling knife