Corn puffing machine is a common puffing equipment we use. Before use, the corn puffing machine must be debugged to ensure smooth operation. What should debugging do? Below, a professional from Jinan puffing machine will introduce:
1. Before use, remove the nozzle of the corn puffing machine, apply some cooking oil to the internal threads and screw heads of the nozzle, then tighten the nozzle, tighten the front flange, and mix the rear flange evenly.
2. After turning on the machine, let it idle for half a minute. If there is no abnormal noise, you can put wet corn into the machine one by one. When the sprayed corn flowers can be crushed by hand, you can replace them with dry corn and gradually increase the amount of input.
3. If the corn puffing machine returns during operation, it indicates that the feeding is too urgent and the nozzle temperature cannot reach 120 degrees. At this time, the feeding should be stopped and the machine should be turned to the nozzle for re spraying before feeding. If the flowers on the nozzle have hard nuclei, it indicates that the temperature inside the machine is low. Stop feeding and idle for a while, and wait for the flowers to spray normally before feeding.
How should we maintain the puffing machine equipment after use? Firstly, due to the relatively fast wear of vulnerable parts near the discharge port and the less wear of vulnerable parts near the feed port, when replacing vulnerable parts, they should be replaced sequentially from the discharge end, and it is not advisable to replace multiple components at once. Secondly, the expansion material should be cleaned to prevent foreign objects such as metals from entering the machine and damaging the parts. The quality of the expansion machine should be checked at any time, and attention should be paid to replacing vulnerable parts.