Xinnuo brand electric 30 ton powder tablet press cold pressing prototype

NegotiableUpdate on 01/21

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The SDY-30 electric powder tablet press prototype of Xinnuo brand electric 30 ton powder tablet press is mainly used for small-scale powder forming in laboratories and can be used for product sampling in industries such as ceramics, powder metallurgy, and cement.

Product Details

Desktop cold press laboratory powder press New Nuo brand SDY-30

Main technical specifications of electric tablet press:

model	SDY-30 (manual+electric)
pressure range	0-30 tons (0-35MPa)
Power supply	220V/50Hz
Power	180W
piston diameter	Φ105mm
Large piston stroke	20mm
workbench diameter	Φ98mm
workspace	165×165×150mm
Pressure stability	≤1MPa/5min
Overall dimensions	405×390×495mm
Weight	87 kilograms

Note: Due to product updates, the above technical indicators are for reference only. Please consult customer service for details. Thank you!

Troubleshooting of electric tablet press:

fault	reason	exclusion method
No pressure	1. Insufficient oil level or severe vibration in the oil tank causes intake into valve 15 2. The steel ball seal at the valve port of outlet valve 16 is not tight or there are foreign objects 3. The rising transition of the large piston causes the intake of air into valve 15	1. Add 30 # engine oil from oil injection hole 14 and follow the instructions in step 3 2. Use a 6mm hex wrench to unscrew valve screw 16, remove the spring, and then use a 6mm iron rod or screw, with one end holding the steel ball and the other end attached with a magnet, to suck out the steel ball, clean the iron filings or foreign objects, and then reset them in sequence 3. Use an Allen wrench to loosen valve screw 15, inject oil, hold the valve port with your fingers, start the machine, and when you feel very strong, tighten valve screw 15 again
Unstable upward pressure, slow down	1. Oil leakage 2. Insufficient tightening force of drain valve 7 3. There is residual gas in the small plunger pump 4. There is residual gas inside the large piston 6	1. Check the oil leakage, tighten or eliminate it 2. Tighten the oil drain valve handwheel 7 3. Tilt the entire machine back 90 degrees (with the surface facing upwards) and start the machine for a few seconds (tighten the oil injection hole screw 14 when tilting back to prevent the oil pool from overflowing outward) 4. Remove workbench 5, unscrew the top large screw, close the oil drain valve 7 and press it until the oil overflows, then tighten the top screw
After reaching the predetermined pressure, do not stop the machine until it exceeds * heightpressure limiting	1. The lead wire of the electric contact pressure gauge has fallen off 2. Internal fault of electric contact meter 3. Relay contact adhesion	1. Check and connect the leads properly 2. Repair or replace the meter 3. Replace with a new relay

Note:Our company's product information comes from information provided by manufacturers, websites, brochures, etc. The quality is reliable and guaranteed! However, due to the new advertising law, which prohibits the use of descriptive and functional words, as well as situations such as whether there is a number written or expired, our company is gradually investigating and revising to improve. Users are also welcome to provide feedback, and our company will give away a beautiful small gift. And we solemnly declare that all extreme words or prohibited words on our company's pages are invalid, and we do not accept any form of online fraud under the guise of "anti-counterfeiting" without compromise. Please make way for real consumers, and we also ask professional "anti-counterfeiting experts" to show their respect