Supply of second-hand 5-ton enamel mixing kettle - second-hand reaction kettle

Supply of second-hand 5-ton enamel mixing kettle - second-hand reaction kettleIt is a type of reaction equipment that must be carefully operated, otherwise it may cause damage due to various reasons, leading to production being forced to stop. There are many aspects to pay attention to when operating a reactor.
Firstly, it is necessary to strictly operate the reactor according to the rules and regulations.
Secondly, before operation, carefully check for any abnormalities. During normal operation, do not open the upper cover or touch the wiring terminals on the board to avoid electric shock; It is strictly prohibited to operate under pressure; During the nitrogen pressure test, carefully observe the changes in the pressure gauge. Once the test pressure is reached, immediately close the nitrogen valve switch; The heating rate should not be too fast, and the pressurization should also be carried out slowly, especially the stirring speed, which is only allowed to increase slowly.
Afterwards, when the kettle body is heated to a higher temperature, do not come into contact with the kettle body to avoid burns; After the experiment, the temperature should be lowered first. Do not cool quickly to prevent damage caused by excessive temperature and pressure differences. At the same time, it is necessary to unplug the power supply in a timely manner.

Supply of second-hand 5-ton enamel mixing kettle - second-hand reaction kettleAt the same time, attention should be paid to maintenance of the reaction kettle after use, so that the high-pressure kettle can have a better service life.A reaction vessel is a comprehensive reaction vessel, and the design of the structure, function, and configuration accessories of the reaction vessel is based on the reaction conditions. From the beginning of the feeding reaction discharging process, the pre-set reaction steps can be completed with a high degree of automation, and important parameters such as temperature, pressure, mechanical control (stirring, blowing, etc.), and reactant/product concentration during the reaction process can be strictly regulated. Its structure generally consists of a kettle body, transmission device, stirring device, heating device, cooling device, and sealing device. Corresponding auxiliary equipment: fractionation column, condenser, water separator, collection tank, filter, etc.

In a stationary state, cut off the power supply of the enamel reaction kettle motor, open the rear cover of the motor, and manually rotate the motor fan blades to drive the stirring shaft to rotate through the reducer. Measure the radial deflection of the mixing shaft at the mechanical seal using a dial gauge. Measure three times. If the stirring shaft of the glass lined reaction kettle fails to meet the above standards during testing, the cause of the problem should be promptly identified. If it is caused by improper installation, it should be reinstalled. If it is a problem with the equipment itself, it should be promptly contacted with the supplier to negotiate a solution. To manipulate the reaction time of the enamel glass reactor, the opening of new houses is not very fast. In the actual operation of the machinery and equipment, people usually rush to achieve results, and the machinery and equipment rotate to a large value. In fact, this method is usually not worth the loss. In such cases, the machine equipment is very prone to large reversals, which will cause deformation in the stirred tank.