Small shock-absorbing flat plate vibration testing platform

Introduction to vibration platform:

　　Small shock-absorbing flat plate vibration testing platformThe equipment is mainly used for compacting materials, and it consists of four parts: a large bracket, the surface of the platform, a vibration motor, a shock absorber, etc. When performing vibration work, it will vibrate in two dimensions - up and down - under the drive of the vibration motor, and can also vibrate in three dimensions - horizontal, vertical, and up and down. Therefore, it can also be called a compaction table. Generally, in the metallurgical and building materials industries, large pieces of materials need to be compacted, and this compaction platform can replace our manual labor. Its work efficiency is higher, the quality is better, and it is relatively easy to operate. Its structure is simple, and it occupies a small area. It can effectively remove the air and debris left in the materials. The small gaps decrease and become less, So more and more industry producers are choosing to use vibration platforms when compacting materials.

Characteristics of vibration platform:

1. After careful design and accurate calculation, the tabletop board is sturdy, with a uniform surface and a beautiful appearance without burrs.

2. The tabletop design is scientific, with high working frequency, simple installation, and easy operation.

3. The standard specifications are complete and can also be customized according to customer requirements.

4. Q235 thickened plate or stainless steel plate gravity casting.

Technical parameters of vibration platform:

Precautions for using vibration platform:

1. Should beSmall shock-absorbing flat plate vibration testing platformInstalled on a solid foundation, the anchor bolts should have sufficient strength and be tightened, and an underground tunnel must be left in the middle of the foundation for frequent adjustment and maintenance.

2. Before use, it is necessary to conduct inspection and trial operation to check whether the parts are intact. All fasteners, especially bearing seat bolts, eccentric block bolts, motor and gearbox bolts, must be securely fastened.

3. The vibration platform should not operate without load for a long time. In production operations, it is necessary to install a sturdy and reliable template locking fixture to ensure that the template and concrete table vibrate together.

4. The gears in the gearbox should be well lubricated and cooled due to high-speed and heavy loads; The oil level inside the tank should be maintained at the specified level, and the temperature rise during operation should not exceed 70oC

5. All bearings of the vibration table should be regularly inspected and the lubricating grease should be replaced regularly to ensure good lubrication of the bearings. Attention should be paid to checking the temperature rise of the bearings. If there is overheating, measures should be taken immediately to eliminate it.

6. The grounding of the motor should be good and reliable, and the power cord and wire joints should have good insulation. There shall be no damage or leakage.

7. The vibration table should be kept clean and flat regularly to ensure good contact with the steel mold. Due to the vibration of the tabletop under high-frequency heavy load, cracks are prone to occur, and it is necessary to pay attention to inspection and repair in a timely manner. After completing each shift's homework, it should be cleaned promptly.