Piezoelectric integrated HN600 vibration transmitter

Piezoelectric integrated HN600 vibration transmitter

Instruction Manual

Overview

Piezoelectric integrated HN600 vibration transmitterThe built-in piezoelectric element senses vibration acceleration, and through high-precision integrated circuits, converts the effective value of acceleration or the integrated effective value of velocity into a corresponding range of 4-20mA current output for remote display and control; Very suitable for connecting to DCS, PLC, and data acquisition systems.

HN600Type piezoelectric integrated vibration transmitterPurpose:

Used for online vibration monitoring of steam turbines, ventilators, blowers, fans, electronic motors, pumps, centrifuges, separators, generators, turbines, and similar oscillating mechanical equipment.

HN600Characteristics of piezoelectric integrated vibration transmitter:

1The two-wire loop makes the use and maintenance of the transmitter more convenient and economical;

2Fault tolerant technology allows for arbitrary polarity connection between two loop wires;

3The low-power and high stability measurement circuit ensures high-precision current output that linearly corresponds to vibration values;

4Piezoelectric core, integrated structure, long lifespan, sturdy and durable, suitable for various harsh environmental conditions;

parameter

electricity Source:+24±10%VdcPower supply, high power consumption0.5W；

Measurement range:0～10gor0～100mm/s; (optional range)

Frequency range:10～1000Hz；

Sensitive direction: axial, any direction/Angle installation;

Lateral sensitivity:≤3%；

Electrical isolation:500VRMSIsolation between the circuit and the casing;

Current output: Standard two-wire system4～20mAOutput;

(Proportional to the effective value of measured vibration) Accuracy:±1%(Heavy load:500Ω）

Impact limit:1000g；

quality Quantity:0.2Kg；

ruler Inch:24*60mm

An Install:M10*1.5orM8*1.25screw Or magnetic suction seat

Protection levelIP68

Usage environment:-30～100℃；

Relative humidity: not greater than95%No condensation.

use

1Before using the vibration transmitter, check if the wiring is intact, and then fix the transmitter at the measured point;

2Confirm that the working power supply of the vibration transmitter should be+24V±10%VDC；

3When the vibration transmitter is powered on and there is no vibration, the output current should be4.00 mA左右；

4The tested machine vibrates, and the output of the vibration transmitter should respond linearly to the vibration4~20mACurrent output;

Wiring diagram:

selection

HN600- A□□□–B□□- C□□