PC400 Strong Crusher Price

PC400 Strong Crusher PriceThe material is crushed by the claw shaped knife on the moving blade disc and the fixed knife on the static blade holder through cutting motion in rotary motion. Very suitable for crushing soft and elastic materials, such as waste plastics, beverage bottles, nylon fabrics, strapping, unsintered gears, etc.

PC400 Strong Crusher PriceMalfunctions and solutions:

1、 The discharge particles of the plastic crusher are too large

1. It indicates that the chuck head is worn and needs to be adjusted to idle or replaced,

2. The gap between the hammer head and the counterattack plate is too large, usually adjusted to 15-20mm,

3. Excessive feed particle size can also affect the discharge particle size.

IIPlastic crusher belt flipping

1. The belt is worn and needs to be replacedV-belt，

2. Due to assembly issues with the belt conveyor, it is necessary topulleyAdjust on the same plane,

3. Be sure to pay attention to the quality of the triangle belt itself

IIIThe production of plastic crushers has decreased

Reason: The gap between the screening strips is blocked; Uneven addition of ingredients.

Exclusion method: Stop the car and clean the blockage in the gap of the sieve strip; Adjust the feeding mechanism.

4Elastic coupling produces knocking sound

Reason: Loose pin shaft; Wear of elastic ring;

Troubleshooting method for plastic crusher: Stop and tighten the pin nut; Replace the elastic ring

5The machine produces a knocking sound inside

Reason: Non broken materials enter the interior of the machine; The fasteners of the lining plate are loose, and the hammer hits the lining plate; Hammer or other parts break.

Exclusion method: park and clean the crushing chamber; Check the fastening condition of the lining plate and the gap between the hammer and the sieve strip; Replace the broken parts.

6、 Plastic crusherBearing overheating

1greaseInsufficient, excessive lubricating grease, dirty and deteriorated lubricating grease, the bearing should be cleaned first, and then 50% of its spatial volume of lubricating grease should be added to the bearing,

2. The bearing is damaged and needs to be replaced in a timely manner,

3. The upper cover is too tight, and the bolts should be adjusted properly with moderate tightness.