Glass bottle verticality deviation tester

With the popularization of automatic filling lines, the verticality of bottles is becoming increasingly high, and the determination of the center of the bottle mouth has always been a difficult problemGlass bottle verticality deviation testerBecome a multi industry * device. Each verticality tester needs to be professionally debugged and tested by professional technicians before sales and delivery. The debugging difficulties can be generally divided into:

1. The problem of motor and chuck gear meshing

During the power on process of the verticality tester, the gear on the motor rotates to drive the gear on the chuck to rotate at a constant speed, and also drives the chuck to rotate at a speed of up to 5 revolutions per minute. Due to the torque issue of the motor itself, it is necessary to adjust the meshing distance between the gears on the motor and the gears on the chuck. If the meshing is too tight, it will cause difficulty or inability to rotate the gears. If the meshing between two gears is too loose, it will cause one of the motor gears to rotate alone. Therefore, it is necessary to carefully adjust the direct meshing problem between the two gears before leaving the factory.

1. Chuck accuracy debugging issues

Before leaving the factory, the verticality tester adjusts the accuracy of the chuck * line through the dial gauge on the pole. The probe on the dial gauge is gently attached to the outer disc of the chuck, and the accuracy of each angle is adjusted through the rotation of the chuck. At the same time, different values are displayed on the dial gauge. It is required that the accuracy standard value of each angle of rotation of the chuck should be controlled within less than 0.05mm. Therefore, the accuracy adjustment of the verticality tester's chuck accuracy should also be very accurate.

The CZ-1 model from Randmecglass bottleverticality deviationtestceremonyFor example, according to the sampling rules, install the sample bottle to be tested in the chuck, adjust the measuring head so that it is aligned with the circular part of the upper part of the bottle body, reset the instrument number, and turn on the rotary switch (observe whether the measuring head cannot contact the bottle, and if so, readjust the measuring head). Rotate a few times and press the corresponding key to get itValue andA small value, half of the difference is the value of the bottleverticality deviationPlease note that if testing plastic bottles, it is recommended toFill the bottle with water to prevent the measuring head from compressing and deforming the bottle.

Plastic bottlesverticality deviationThe main factors affecting product quality can be ensured through reasonable control of shaft deviation, which not only guarantees good performance but also avoids damage to the filling line.