High speed and high torque mixerA machine that mixes multiple raw materials into a mixture or suitable consistency. Widely used in equipment for mixing, dispersing, and dissolving coatings and solids, as well as chemical products such as inks, pigments, adhesives, etc. The equipment consists of five parts: hydraulic system, main transmission, mixing system, guiding mechanism, and electric control box. The structure of each part of the equipment is compact and reasonable.
The instrument should be installed on a flat and solid site, surrounded by good drainage channels, and a sturdy operating shed should be set up as required. Fixed machinery should have a reliable foundation, while mobile machinery should be firmly supported on a flat and hard floor with square wood or brackets, and kept level. When the temperature drops below 5 ℃, anti freezing and insulation measures should be taken for pipelines, pumps, and machinery.
When the stirring element jumps or does not stir during stirring, please cut off the power and check whether the bottom of the beaker is flat and the position is correct. At the same time, please measure it. The current voltage used is between 220V ± 10V, otherwise the following situations will occur.
Do not let the instrument work without heating the liquid.
Medium speed operation can work continuously for 8 hours, high-speed operation can work continuously for 4 hours, and prevent severe vibration during operation.
The heating time should generally not be too long, intermittent use can prolong the service life, and heating should not be done when not stirring.
The instrument should be kept clean and dry, and the solution should strictly flow into the machine to avoid damaging it. When not working, the power should be cut off.
The power socket should use a three hole safety socket and must be properly grounded.
Before operating the machine, it should be checked whether it is grounded to ensure completion before starting work.
High speed and high torque mixerThe internal components have an upper limit for heating, so when heating, it is important to consider ensuring that the machine does not continue to heat up and remember to change the motor's state to rotating.
In order to ensure that the instrument is not damaged, insulation materials are usually placed inside the instrument. Therefore, a small amount of white smoke or a pungent smell may be observed during use, which is a normal phenomenon and not a product quality issue. Keeping ventilation is sufficient.
After the heating work is completed, be sure to turn off the heating first, and wait for a few minutes until the temperature has dissipated before turning off the stirring.