Working principle of oil separation lifting deviceIt is to add chemicals to the main equipment for treating sewage, in order to facilitate the acid-base balance or flocculation of sewage, and other accessories will not be elaborated one by one. Different sewage treatment processes require different equipment models.

1. Control of sedimentation tank sludge discharge, using solenoid valve air lift or sludge pump to lift the sludge, with a sludge discharge cycle of 8 hours and a discharge time of 8 minutes. When the gas is lifted, two fans start simultaneously to ensure the supply of gas.
2. Multiple sewage treatment tanks, such as sedimentation tanks, regulating tanks, anaerobic tanks, aerobic tanks, disinfection tanks, etc., are concentrated together, and then organic matter is treated through anaerobic and aerobic technologies to reduce BOD and COD content and meet discharge standards.
3. Unlike underground sewage treatment equipment made of carbon steel with anti-corrosion treatment, which may rust and leak after two to three years, fiberglass tanks have a service life of more than 30 years and are considered usable products with timely replacement of components.
4. PAC and PAM are added to the sewage pipe mouth, and thoroughly mixed through the mixing pipe at the bottom of the air flotation tank. Then, they are mixed with some positively charged microbubbles generated by dissolved air, allowing the microbubbles to adsorb pollutants from flocs and wastewater, and bridge air flotation water distribution.
5. Sewage treatment equipment has strong adaptability to water, reliable operation, and stable effluent quality.
If it is necessary to stop the 1 # pump, press the start/stop button again to lift the 1 # pump. At this time, the 1KM device will be released and the 1 # pump will stop.
7. There are also some supporting equipment for sewage treatment, such as dosing devices.
According to the installation diagram, use a crane to lift the steel structure pool into place. The installation must be carried out under the guidance of our technical personnel, and the position and direction of the box cannot be placed incorrectly. Our company is responsible for the pipeline connection between the pools.
9. Sand settling equipment: horizontal flow sand settling tank, vertical flow sand settling tank, aeration sand settling tank, bell shaped sand settling tank.

1. Air flotation equipment: electrolytic air flotation equipment, dispersed air flotation equipment, dissolved air vacuum air flotation equipment, pressurized dissolved air flotation equipment.
2. Air purification equipment: Air purification equipment is an environmentally friendly device used to purify the air. It can be used to purify the air in homes or industrial areas.
3. Clean the anaerobic tank once a year to prevent sludge accumulation. When operating in anaerobic tanks, all inspection manhole covers should be opened for forced ventilation before entering to ensure safety and prevent suffocation or poisoning accidents.
4. Exhaust the dissolved gas water pump and gradually open the outlet water pipe valve until it is fully opened after starting.
5. The material of the multi-media filter can be fiberglass, A3 steel anti-corrosion or rubber lined, or all stainless steel. There are two types of operation modes: fully automatic and manual. Automatic control adopts automatic controllers and pneumatic and hydraulic valves imported from the United States. It is easy to operate and maintain, and has been widely used in pre-treatment devices of water treatment processes in various industries.
6. The sewage treatment equipment for small dental hospitals does not require any raw materials and can be used for life after being put into operation once.
7. In the experiment, the flow rate of the toxic agent solution for collaborative elimination in the continuous electrolytic cell was measured using the volumetric method. Each flow parameter should be sampled at least 3 times, with each sampling time not less than. The measurement result should be the average of several measurements.

Working principle of oil separation lifting device