Used spray 2m3 enamel double cone dryer

This machine is designed with a simple internal structure, easy cleaning, and can discharge all materials. It is easy to operate and can reduce labor intensity to improve the working environment (if solvent recovery is not required, the condenser can be omitted). At the same time, due to the rotation of the container itself, the material also rotates but there is no accumulation of material on the wall, resulting in a high heat transfer coefficient and a high drying rate. This not only saves energy, but also ensures uniform and sufficient drying of the material, resulting in good quality. It can be widely used for drying materials in industries such as pharmaceuticals, chemicals, food, dyes, etc. Meets GMP requirements.

The double cone dryer is a rotary tank with a double cone shape. In a vacuum state, steam or hot water is introduced into the jacket for heating, and the heat contacts the wet material through the inner wall of the tank. The water vapor evaporated from wet materials after absorbing heat is pumped out through a vacuum exhaust pipe by a vacuum pump. Due to the vacuum state inside the tank and the continuous flipping of the material up and down, inside and outside caused by the rotation of the tank, the drying speed of the material is accelerated, the drying efficiency is improved, and the goal of uniform drying is achieved.

feature

The drying speed is fast, usually only a few seconds to a dozen seconds, with the characteristic of instant drying. The temperature of the droplets during the drying process is relatively low, which is particularly suitable for drying thermosensitive materials and can maintain the color, aroma, and taste of the materials. To prevent wall sticking in the drying tower, this device is equipped with a special structure to effectively eliminate the phenomenon of product wall sticking. *The finished product air delivery system separates the dried product from the hot and humid air inside the system in a timely manner, avoiding the possibility of moisture absorption or agglomeration of the dried product The boiling point of the material solution decreases under vacuum, which increases the heat transfer driving force of the evaporator, thus saving the heat transfer area of the evaporator for a certain amount of heat transfer; The heat source for evaporation operation can be low-pressure steam or boiling steam; The evaporator has minimal heat loss and can be disinfected before drying. There are no impurities mixed in during the drying process, which meets GMP requirements; Using a condenser can effectively recover solvents from materials.

Used spray 2m3 enamel double cone dryer Used spray 2m3 enamel double cone dryer