Phoenix transmitter MINI MCR-SL-U-U-SP in stock*

Phoenix transmitter MINI MCR-SL-U-U-SP in stock*
Isolation amplifier - MINI MCR-SL-U-U-SP -2864697
MCR 3-terminal isolation amplifier, used for electrical isolation of analog signals, spring wiring, input signal: 0 .. 10V/± 10V, output signal: 0 .. 10V/±10V

size

Width 6.2 mm
Height 93.1 mm
Depth 102.5 mm
Back to top
environmental conditions

Environmental temperature (operating) -20 ° C... 65 ° C
Environmental temperature (storage/transportation) -40 ° C... 85 ° C
Back to top
Input data

Input quantity 1

Phoenix transmitter MINI MCR-SL-U-U-SP in stock*
Configurable/Programmable No
Voltage input signal 0 V... 10 V
-10 V . .. 10 V
The maximum input voltage is 30V
The input resistance of the input voltage is approximately 100 k Ω
Back to top
output data

Output quantity 1
Configurable/Programmable No
Voltage output signal 0 V... 10 V
-10 V . .. 10 V
The maximum output voltage is 12.5 V
Short circuit current is approximately 2 mA
Load/output load voltage output ≥ 10 k Ω
Fluctuations<20 mVSS (at 10 k Ω)
Back to top
power supply

Rated supply voltage 24 V DC
The power supply voltage range is 19.2 V DC... 30 V DC (DIN rail bus connector (ME 6,2 TBUS-2 1,5/5-ST-3,81 GN, order number 2869728) can be used to bridge the power supply. Can be clipped onto a 35 mm DIN rail that complies with EN60715 standard)
Maximum current consumption<9 mA
Power consumption<200 mW (24 V DC)
Back to top
Wiring data

Connection method: Pull back spring connection
Rigid wire with a minimum cross-sectional area of 0.2 mm ²
Rigid wire with the largest cross-section of 2.5 mm ²
Zui small wire cross-sectional AWG 24
Zui large wire cross-sectional AWG 12
Flexible wire with the smallest cross-section of 0.2 mm ²
Flexible wire with the largest cross-section of 2.5 mm ²
Stripping length 8 mm
Back to top
Overview

Number of channels 1
Maximum transmission error ≤ 0.1% (final value)
The maximum temperature coefficient is less than 0.01%/K
Temperature coefficient, typical value<0.002%/K
Cut off frequency (3dB) is approximately 100 Hz
Step response (10-90%) is approximately 3.2 ms
Protection circuit transient protection
Electrical isolation complies with the basic isolation of EN 61010
Surge voltage category II
Pollution level 2
Rated insulation voltage 50 V AC/DC
Test voltage, input/output/power supply 1.5 kV (50Hz, 1min)
Electromagnetic compatibility complies with the Electromagnetic Compatibility Directive
Emission interference EN 61000-6-4
When the noise resistance EN 61000-6-2 is disturbed, it may be the smallest deviation.
Color Green
Shell material PBT
Installation location is arbitrary
Assembly instructions: The T-shaped connector provides bridging power supply for the module. Can be clipped onto a 35 mm DIN rail that complies with EN 60715 standard.
Compliance with CE standards
ATEX  II 3 G Ex nA IIC T4 Gc X
UL， UL 508 certification in the United States/Canada
Class I, Div. 2, Groups A, B, C, D T5