Alumina bulk density meter

Aluminum fluoride and aluminum oxide flow time measuring instrument,Aluminum oxide flowability tester,Aluminum fluoride flowability tester,Aluminum fluoride loose density meter,Aluminum oxide loose density tester

1、 According to complianceGB∕T 6609.25-2004Technical specification for chemical analysis methods and determination of physical properties of alumina - Determination of bulk density. Chemical analysis methods and physical property determination methods for alumina Part25Determination of Partial Loose Density

2、 Technical parameters of alumina bulk density tester:

1Funnel: Inner diameter of mouth100mm, taper angle60oInside the discharge port6mm.

2Measuring cylinder:make an appointment200ml1The ratio of inner diameter to inner height6：Outer diameter of the base

370mm

Material: Stainless steel material

Aluminum fluoride flow measurement deviceFunnel: made of stainless steel material, with an outer diameter at the upper opening of the funnel138.5mm,inside diameter123mm

,The outlet diameter is3.95mm～4.0mm,Total height190.5mm

Wear resistant stainless steel.Upper mouth taper:60°Taper of discharge port15°

.

1Aluminum fluoride loose density measuring deviceFunnel: upper inlet diameter100mm, taper angle60°, neck length8mmInside the lower discharge port6mm

2.Cylindrical container: with a capacity of approximately200mL1The ratio of internal meridian to internal height6：

3The inner bottom is flat.