750L/H fully automatic reverse osmosis purified water equipment

The 750L/H fully automatic reverse osmosis purified water equipment mainly uses a pretreatment system to addReverse osmosis deviceA complete set of integrated equipment composed of advanced technology from todayreverse osmosis membraneThe process produces industrial pure water, and the pretreatment system includes fully automatic mechanical filters, fully automatic activated carbon filters, fully automatic softening filters, and well-known domestic brandsFully automatic control valveThe reverse osmosis device includes a stainless steel 304 bracket, an electronic control system, a water flow meter, a concentrated water flow meter, a flushing solenoid valve, a pressure gaugeDow reverse osmosis membrane from the United StatesStainless steel 304 reverse osmosis pressure vessel.

1750L/HTechnical parameters of fully automatic reverse osmosis purified water equipment:

1. Inlet flow rate: Inlet flow rate ≥ 1.5m³/h

2. Power supply system: 380V/50HZ, 220V/50HZ ± 10%

The total installed capacity is 1.65KW

3. System water inlet requirements

a、 Raw water pressure: 30psi (0.2Mpa)

b、 Water supply flow rate: ≥ 1.5m³/h

c、 Water temperature: 15 ℃ -30 ℃

d. PH range: 6-8

e、 Hardness: 75mg/L (calculated as CaCO3)

f、 Total dissolved solids content: TDS<200PPM

4. Equipment footprint: 1.6 meters long * 0.7 meters wide * 1.65 meters high (excluding water tank)

5. Equipment height: 1.65 meters

6. Site requirements: The height of the factory building is ≥ 3m, the ground is flat, and it can bear weight; There are drainage ditches and ventilation devices indoors.

7. Supply scope: from raw water inlet toPure water tankAll equipment, pipelines, valves, instruments, etc. The user sends the power supply to the system powerOn the device.

8. Introduction to the specific situation of the system

a、 System operation shift: The entire system runs continuously;

b、 Water supply method: continuous water supply;

c、 Operation mode: The entire system is fully automatic controlled (the pre-treatment bed is controlled by multiple valves,Reverse osmosis hostUsing automatic control, with other interlocking protections.

9. Water production and technical requirements

a. System terminal water production ≥ 0.75T/H

b. Using municipal tap water as the system inlet, the conductivity of the terminal produced pure water is ≤ 10us/cm (subject to online monitoring by the instrument of this equipment)

II750L/HProcess flow of fully automatic reverse osmosis purified water equipment:

Raw Water Tank - Raw WaterPump - Fully automatic mechanical filter - Fully automatic activated carbon filter - Fully automatic softening filter -5U security filter - High pressure pump - Fully automatic reverse osmosis device - Pure water tank

III750L/HConfiguration List of Fully Automatic Reverse Osmosis Pure Water Equipment:

Related searches:What is the general production rate of purified water equipment What are the pollution and pollution control methods for reverse osmosis membranes? Improper operation of reverse osmosis equipment can cause damage to the performance of RO membranes