350 liter SCY (LCD programmable) constant temperature and humidity incubator _ Constant temperature and humidity incubator manufacturer

Constant humidity and temperature incubatorFunction:

Controlled by a microprocessor, it has functions such as monitoring, temperature control, and protection. Indoor lighting: can observe the culture inside the box, stainless steel inner liner, and corrosion.

350 liter SCY (LCD programmable) constant temperature and humidity incubator _ Constant temperature and humidity incubator manufacturer

Constant temperature and humidity incubatorTechnical Specifications:

Constant temperature and humidity incubatorFeatures:

1.The outer box of this equipment is made of cold-rolled steel plate, and the surface is coated with electrostatic spraying technology. The inner box is made of stainless steel, and the insulation layer is formed by polyester foam. The transparent window uses double-layer hollow glass to ensure the insulation performance inside the box (low-temperature incubator and...)BODFor incubators that require stainless steel finish without glass windows, there are cold and hot air ducts in the box body to ensure smooth gas circulation and more balanced temperature.

2. Unified adoption“zero crossing”Contactless switch circuit technology enables pulse width modulation heating and cooling, resulting in a temperature control fluctuation range smaller than0.5℃The internal non-uniformity is1.0℃左右。

350 liter SCY (LCD programmable) constant temperature and humidity incubator _ Constant temperature and humidity incubator manufacturer

Constant temperature and humidity incubatorUsage:

1Usage conditions:
AEnvironmental temperature:10-30℃
BNo strong corrosive gases, good ventilation, relative humidity85%below
CUsing power supply:220V±10%The50HZCapacity not less than1KWThere is a good grounding wire.

2Usage of constant humidity and temperature incubator:
ABefore use, place the ultrasonic atomizer next to the machine, add water to the ultrasonic atomizer, connect the gasification pipeline, and plug the power cord of the ultrasonic atomizer into the three wire socket on the right side of the box
BStop humidifying when this machine is heating up

Constant humidity and temperature incubatorNotes:

1.Attention should be paid to adding water in a timely manner when using a humidifier, according to the humidity requirements1-2Add water once a day to prevent damage. When adding water, remove the power plug of the humidifier, take off the humidifier water storage tank, turn it up counterclockwise to open the water sealing port, add water, then tighten the seal tightly, put it on the humidifier, and press the humidifier power on.
2.After the equipment lands, if the ground is uneven, it should be leveled with a cushion.
3.The general movement of the device should be parallel, and any tilt in any direction should be less than45Degree.
4.*No need, the power cord should be disconnected to prevent the equipment from being charged and causing injury, and it should be operated regularly (usually quarterly) according to the usage conditions2-3Tian, to expel moisture from electrical components and avoid damaging related devices.

Constant temperature and humidity incubatorFeatures:

1.The outer box of this equipment is made of cold-rolled steel plate, and the surface is coated with electrostatic spraying technology. The inner box is made of stainless steel, and the insulation layer is formed by polyester foam. The transparent window uses double-layer hollow glass to ensure the insulation performance inside the box (low-temperature incubator and...)BODFor incubators that require stainless steel finish without glass windows, there are cold and hot air ducts in the box body to ensure smooth gas circulation and more balanced temperature.

When this device is operating normally, the placement of the contents inside the box should not affect air circulation to ensure uniform temperature inside the box. The inner lining of the box wall and the surface of the equipment should be regularly wiped to maintain cleanliness.