Water bath pots are mainly used for distillation, drying, concentration, and temperature soaking of chemical or biological products in laboratories. They can also be used for constant temperature heating and other temperature tests. They are tools for biology, genetics, viruses, aquaculture, environmental protection, medicine, health, laboratories, analysis rooms, education and scientific research.

Maintenance methods
(1) Before use, an appropriate amount of clean tap water must be added to the pot, or hot water can be added at the desired temperature to shorten the heating time.
(2) Connect the power and select the temperature.
When equipped with an electronic thermostat, adjust the "temperature knob" clockwise to the desired temperature, which is the heating state and the green indicator light is on. When heated to the desired temperature, the red indicator light will turn on, indicating a constant temperature state.
When equipped with a digital display head, the large digit of the counter is ten, and pressing the operation symbol is an increase, and pressing the operation symbol is a decrease. Traffic lights switch with changes in body temperature. Similarly, the green light indicates that the heater is working, while the red light indicates constant temperature.
The use of this instrument requires heating and constant temperature at least twice to achieve the correct temperature accuracy (it must be fully covered and sealed).
(3) After completing the work, set the temperature control knob and the controller to low values and cut off the power.
(4) If you want the water temperature in the pot to reach 100 ℃ for boiling water distillation, you can adjust the knob to the endpoint.
(5) Do not add too much water to prevent the water from overflowing outside the pot when boiling.
(6) The amount of water in the pot should not be less than half, and the heating tube should not be exposed to the water surface. To avoid burning out, causing water and electricity leakage.
(7) When using this product, the three pin socket must be effectively grounded.