A fuel heater is mainly a device that uses fuel as fuel to generate heat and is used for cold insulation and heating. This heater has the characteristics of being lightweight, flexible, small in size, light in weight, powerful, easy to operate, safe and reliable, requiring less electricity, and saving fuel.

Fuel heaters are divided into two types: industrial and household. Widely in the industrial field. In the industrial field, it is mainly used for heating large spaces such as commercial and industrial places, buildings, bridges, etc. It can also be used for drying some industrial products. As the name suggests, it heats the air. Traditional coal-fired, gas-fired, commonly electric heating, and the rising trend of oil fired heating. Among various heating methods, air heating is relatively comfortable, and fuel heating, as an emerging air heating method in industry, can also provide clean and dry hot air to heat the entire space with uniform temperature. It has the advantages of rapid heating and fast heat circulation.

When using this device, attention should be paid to the following points: when the temperature is below 0 ℃ in winter, there will be a layer of ice and frost on the front windshield. Start the engine, raise the water temperature to above 40 ℃, place the control according to the indicator on the defrost position, cycle to the indoor circulation position, turn on the blower motor and place it in third gear. At this time, the motor speedRun it for 35 minutes, and then shift the gear to first or second gear according to the defrosting situation. If the motor is found not rotating, immediately return the motor gear to the closed position to avoid burning out the variable speed resistor. When the outside temperature is low and there are many drivers and passengers inside the cab, there may be frost on the glass. The control can be placed in the defrost position and the outdoor circulation position, and the motor can be placed in first or second gear to clean the frost. When there is no sandstorm or dust outside, the circulation can be placed outdoors to make the air fresh. If there is sandstorm and dust or when the weather is too cold, put the circulation indoors to avoid sandstorm and dust entering.

fuel tankRinse the fuel tank every 160-200 hours of operation or as necessary

Filters and filter sponge meshReplace the filter every 500 hours of operation or once a year

Air inlet filterClean and dry with soap and water every 500 hours of operation or as necessary

Fuel injector headClean twice during each heating season, or when necessary

火花塞Clean and dredge every 600 hours of operation or replace as necessary

Wind bladeClean up every season or when necessary