Nine precautions for proper maintenance of fully automatic feeders
1. During the operation of the equipment, it is strictly prohibited to closely observe the operation status of the equipment and open relevant inspection ports for maintenance. If it is necessary to observe the operation status of relevant components during operation, professional personnel need to operate according to regulations and be equipped with necessary personal protective measures.
2. When conducting inspections, repairs, and maintenance, staff must ensure that the main power switch is disconnected and sealed, otherwise serious injury accidents may occur.
3. The installation, maintenance, or upkeep of electrical equipment related to this device must be carried out by professional electrical operators in accordance with regulations, otherwise serious injury accidents may occur.
4. The protective components of the equipment are an important part of the equipment and cannot be removed arbitrarily. In case of damage, they should be repaired or replaced in a timely manner.
5. There are two travel switches installed at both the front and rear of the machine, and the track wheel of the material cart will stop running when it touches any of the travel switches. It is necessary to regularly check whether the travel switch is sensitive. If it fails, it should be replaced in a timely manner, otherwise it is easy to pull the material truck and even lead to more serious consequences.
6. At the bottom of the trough where the eggs roll off, an electric shock wire is set up to prevent the chicken from pecking at the eggs. Please do not touch it with your hands to avoid injury.
7. The power cord of the power supply part needs to have a dedicated protective cover, and the wiring part needs to have a dedicated terminal block to prevent accidents caused by leakage.
8. The operators who use or maintain the equipment must undergo professional skill training and strictly follow the relevant operating procedures.
9. The device is equipped with relevant safety operation warnings. Please pay attention to and carefully read these prompts when using or maintaining it.
After understanding the precautions to be taken during maintenance, let's now learn about the precautions to be taken when using it
1. When the feeder is running, do not put anything on top, as it may cause excessive pressure on the motor and burn it out.
2. Check if the belt is intact and if it is loose. The feeder relies on the conveyor belt to transport materials, and only when the belt is functioning properly can the machine's production performance be fully utilized and the workload be maximized.
3. Because the various components of the feeder are connected by gears and chains, it is necessary to ensure a high degree of lubrication between the gears and chains in order to prevent damage to the machine due to lack of lubrication.
4. Due to the production of feed, a large amount of dust is generated, which accumulates in the control box of the feeder. Dust can cause internal circuits to short circuit, damage electrical circuits and other components, so it is necessary to clean the dust in the control box every once in a while.
5. The main power source of the feeder is the motor, which includes a power motor and a reduction motor (due to the high speed of the motor, a reduction motor is used to reduce the speed when transmitting power). When using, it is important to check whether there are any abnormalities in the power motor and reduction motor. The motor should be maintained in a timely manner, such as adding gear oil to the gears of the reducer.