Surface treatment: Sandblasting rust removal reaches Sa2.5 level; The roughness reaches 70-100 microns

Mixing rule: This coating is a two-component, packaged in two cans. When using, be sure to mix according to the provided component ratios

Hehe. Strongly stir component A to achieve uniform viscosity and color, until the blocks accumulated due to storage

The precipitate is uniformly mixed; Slowly mix the curing agent into component A mentioned above. Mix thoroughly until viscosity and

Until the color is uniform.

Cleaning solvents: acetone, methyl ethyl ketone

Environmental conditions for construction: The temperature of the coated surface should not be lower than 10 ℃ and should be 3 ℃ higher than the dew point temperature of the base surface

Up; Preheat the raw materials to 20-30 ℃ before mixing and spraying. Too high a temperature will shorten the already mixed paint

Applicable period.

Application: Airless spraying equipment, pump ratio 45:1 (at 80-100 pounds), nozzle pressure reaches 16.5-20.6 MPa,

The nozzle diameter is 0.48-0.58mm, the bend diameter is 4.78mm (3/16 "), the length is 152mm, and the maximum length does not exceed 2.5 meters

This coating belongs to low VOC materials. If the construction viscosity needs to be adjusted on site, a small amount of methyl ethyl ketone can be used for adjustment.

Storage precautions: For detailed information, please refer to the Material Safety Data Sheet (MSDS). During storage, construction, and drying

During the use of this product, appropriate safety and hygiene measures must be taken. This product should be implemented in accordance with local regulations

Proper use of industrial and environmental regulations.

Common packaging quantity: 5 gallons (19 liters) and matching curing agent; 1 gallon (4 liters) and matching curing agent.