Maintenance matters for V-type mixer
1. Suitable for an ambient temperature of -5 ° C? C40? C， Relative humidity<90%, suitable constant temperature, should be placed in a ventilated, dry, and clean location.
2. Minors are strictly prohibited from touching this machinery without authorization to avoid accidents.
3. The lubrication of the reducer adopts oil immersed type, and its oil storage capacity must be maintained at the oil standard line, and the oil quality must be kept clean. If frequently used, it is necessary to change the oil every three months. When replacing, the reducer should be disassembled, cleaned, and then filled with new oil.
4. The electrical control components of the mixer should be kept clean and sensitive, and any malfunctions should be promptly repaired.
5. After a single use or shutdown, the remaining materials in the V-shaped bucket should be removed and the residual powder in each part of the machine should be cleaned. If the shutdown time is long, the V-shaped mixer must be wiped clean and covered with a tarpaulin.
6. When disassembling the V-shaped bucket, it should be disassembled gently, installed steadily, and placed gently to avoid deformation and damage.
7. Regularly inspect the mechanical components, 1-2 times a month, to check whether the power shaft, transmission, gearbox and other moving parts rotate flexibly and wear out. If any defects are found, they should be repaired in a timely manner to ensure the normal use of the mixer.
Precautions to be taken when using a V-type mixer:
Inspection work before operating the V-type mixer:
① CheckV-shaped mixerThere should be no foreign objects inside, and the inner wall of the hopper should be dry. Open the inlet cover and close the outlet cover.
② Check that there are no obstacles around the mixer to avoid accidents caused by magnetic collisions during operation.
2. Material preparation: Prepare various materials that need to be mixed, and remember that the materials must be dry. If the materials are not dry, this type of mixer cannot be used. We can use our factory's trough mixer or dry them in an oven before performing this operation.
3. Feeding: Add the material from the feeding port, usually only about 50% of the total volume can be added, in order to mix evenly, and then tighten the feeding port cover.
4. Mixing: Turn on the power switch to start mixing materials.
5. Discharge: Open the discharge port cover and use the specified container to load the material at the discharge port until all the material in the hopper is discharged.