Baichao bending machineWhen in use, the coil is energized by a wire, which generates an attractive force on the pressure plate, thereby achieving the clamping of the plate between the pressure plate and the base. Hydraulic bending machine can meet the needs of various workpieces by replacing the hydraulic bending machine mold.
Precautions for using Baichao bending machine:
Before running the bending machine, the tools used must be compatible with the control program;
After the work is completed, be sure to turn off the bending machine.
Method to turn off the bending machine:
1. Turn off the machine tool to the middle position of the bottom dead center, that is, move the slider to the center of the bottom dead center, turn off the main motor, adjust the operation switch to "0", and also adjust the main switch to "0";
2. Use two pieces of wood of the same height to turn off the bending machine, that is, place the two pieces of wood on the workbench and adjust the operation mode selection button to "2". After the bending mechanism is closed, manually pull down the slider until it can touch the wooden block. Adjust the operation mode selection button to "0", and then adjust the main switch to "0".
How to use the emergency stop button of the bending machine?
When using the emergency stop button, all shafts and pumps will stop, but the control system will not shut down. Please restart the machine, release the emergency stop button first, and then press the green button to run the machine. No need to reset the upper and lower mold parameters.
Maintenance requirements for Baichao bending machine:
1. It is recommended that when maintaining and repairing the bending machine, the staff should have certain experience and carefully read the operation manual for the required maintenance of the bending machine;
2. It is recommended to have the bending machine manufacturer inspect the machine tool;
3. Machine operators need to check the machine every day to avoid oil leakage or loose parts of the machine;
If the machine malfunction cannot be resolved by oneself, it is recommended to promptly contact the bending machine manufacturer.
Maintenance of Baichao bending machine components:
1. Check the guide rail once a week and remember to lubricate it;
2. The rear blocking material also needs to be oiled;
3. Check the tightness of the conveyor belt;
4. Clean the dashboard and check the drive part;
5. Clean the mold and check for any damage.